25A Durometer (Pink)- Approximately the hardness of a computer mouse pad. Check out our Hardness Comparison Chart for more information.
This is an addition cure (platinum catalyzed) system. As such, it can be heat accelerated and is subject to inhibition/poisoning by the usual factors which include (but are not limited to) sulfur, sulfur compounds and amines.
While Magikmold™ Silicone Putty can be mixed with clean dry hands (use your palms not your fingers) we recommend coating your hands with a slight amount of mineral oil or petroleum jelly.
Platinum cure silicone putty 1:1 mix. Easy to use and cures in minutes.
It has been noticed by colleges in the food industry that the above mentioned products can be prepared to be compatible for use in light food contact. Below are the steps which must be taken to make this so.
1. Allow mold of the above mentioned product to completely set in accordance to recommended set times.
2. Pre-heat a ventilated oven to 200°C (392°F).
3. Place final mold in pre-heated oven for a minimum of 5 hours.
This process will allow you to use the mold for light food contact. It is important to keep in mind that this is a suggestion and not a certification. Silicone Putty Article
You can request this product in 25A (Pink), 35A (Green), 45A (Blue) & 55A (Yellow) hardnesses
Technical Data Sheet: Magikmold™ Silicone Putty TDS
For your project you may also need: